Escaping hazardous material, Fire Brigade Hamburg
		The Project: Action of the Hamburg Fire Brigade following an accident in which a hazardous material escapes The Problem: Sucking up from the surface of the road the very small residual quantities of the liquid that had escaped.
Our Solution: Use of a residue water pump of type LSC1.4S. This sucks up liquids of depths down to 1 mm in a self-priming manner and then continues to operate in snore mode without supervision. After use the pump was cleaned with fresh water so that the plastic parts and elastomers were not attacked by the liquid.
In the event of abrasive and corrosive utilization, stronger wear and tear will take place naturally in certain components. With regards to the above application wear and tear can take place mainly in impeller, suction plate, shaft sleeve, oil ring, mechanical seal, pump casing, strainer, motor casing and discharge coupling. Depending on the working conditions the lifetime of those parts might vary significantly and can be shorter than the legal warranty period. In this regard, please pay attention to our general conditions of sales (www.tsurumi-europe.com/english/GCS.htm) that we also send to you by mail on request.